Size Setting Mode (Same As Series 8) - EcoSmart GWL10US Service Supplement Manual

If the pump's thermal overload goes open circuit the power to the module will be lost, so no fault
will be reported. When the thermal device has reset, the module will power up normally. This
could take between 3 - 10 minutes depending on the temperature of the pump at the time of
failure.
The number of times the auto restart feature tries to start a stalled pump has been reduced to
prevent nuisance tripping of the pump's thermal overload.
Note:
If the pump has blocked and the thermal overload has gone open circuit, just remove the blockage
from the pump, the module and the pump should still be okay.
If the pump windings are water damaged, the pump will quickly overheat and cut off again. The
pump must be replaced in this case. The electronics should still be okay.
It is important to check the pump windings thoroughly for water damage. It is possible for the
resistance of a water damaged pump to be normal, however the inductance of the pump can
change causing it to overheat and cut out.
There are new fault codes in the system, which now relate to the pump circuit and its extended
function. (Fault code 62, pump over current. Fault code 63, pumps COM's error)

SIZE SETTING MODE (SAME AS SERIES 8)

It is important to set the size of the machine into the Motor Controller's memory whenever a
replacement Motor Controller or Display Module is fitted to the washing machine. Failure to do
this could result in the machine faulting to detailed fault code 9.
To set the size turn the power on at the power point and off at the console. Press and hold the
TEMPERATURE UP button then press the POWER button. The machine will give 4 short
beeps and the pattern of LED's will change.
Press the TEMPERATURE UP button until the COLD LED is on for 5kg & 5.5kg machines.
Press the WATER LEVEL UP button until the LOW WATER LED is on for 6.5kg machines.
Press the SPIN SPEED UP button until the SPIN HOLD LED is on for 7kg/7.5kg machines.
(This is the setting for GWL10)
Press POWER to exit this mode.