Ford Crown Victoria 2004 Owner's Manual page 55

Driver Controls
brand. If there is difficulty locating the "learn" or "smart" button refer to
the device's owner manual or contact HomeLink at 1–800–355–3515 or
on the Internet at www.homelink.com.
2. Press and release the "learn" or "smart" button on the garage door
motor head unit.
Note: Following step 2, there are 30 seconds in which to initiate step 3.
3. Press and release the
programmed HomeLink button.
Press and release the HomeLink
button a second time to complete
the training process. (Some garage
door openers may require this
procedure to be done a third time
to complete the training.)
The rolling code equipped device
should now recognize the
HomeLink signal and activate when
the HomeLink button is pressed. The remaining two buttons may now be
programmed if this has not previously been done. Refer to the "Train
mode" in this section.
Transmit mode
1. Select the button for the desired
channel (for example, for the garage
door you wish to open).
2. Press the button. CHANNEL X
TRANSMIT is displayed.
3. The proper signal is transmitted
to the device being controlled.
4. Release the button.
Note: If more than one button is
pressed, priority will be given to the
lowest numbered channel.
55
2004 Crown Victoria (cro)
Owners Guide (post-2002-fmt)
USA English (fus)