Reversing Door; Reversing Door Swing; Removing The Door - Kenmore Front Load Dryer Installation Instructions Manual

Reversing Door Swing

1. Be sure you have adequate swing area before

reversing door.

2. You will need a screw driver with a #2 square
and straight bit.
3. Protect fl at work surface, such as top of dryer or
fl oor near dryer, with a soft cloth or towel.
4. Be sure dryer is unplugged from power source!

Removing the door

1. Protect fl at work surface, such as top of dryer or fl oor
near dryer, with a soft cloth or towel.
2. Open dryer door and remove the two hinge screws.
Remove lower screw fi rst, then upper screw.
3. Supporting door with both hands, squarely lift door and
hinge upward approximately 3/8" (10 mm) so "T" post
on back of hinge can slide out through "T" slot on front
panel.
"T" SLOT IN
FRONT PANEL
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source
before servicing could result in personal
injury or even death.
"T" POST ON
DOOR HINGE
WARNING
4. Gently place dryer door face down on fl at, covered
work surface.
5. Locate the 5 indented head screws (no. 1-5) in the small,
circular recesses (at 11, 1, 4, 6, and 8 o'clock positions)
of the inner door. Remove and save these 5 screws.
IMPORTANT
Do not attempt to remove the 2 "tamper-resistant"
screws that hold the inner glass in place.
6. Locate the 2 pan head screws (no. 6-7) on the inner
door nearest the metal strike and center of hinge (9
and 3 o'clock positions). Remove and save these 2
screws.
7. Separate inner door assembly from outer door
assembly.
20
Tools needed:
Screwdrivers with
#2 square &
straight bit