Build Intelligent Device Platform Xt Runtime Software - Intel IoT Gateway Development KitDK200 Series Getting Started Manual

Intel IoT Gateway Development Kit DK200 Series —Build Intelligent Device Platform XT Runtime
7.0 Build Intelligent Device Platform XT Runtime
Software
Before you
Begin
Install Linux Packages and Wind River Linux Host Tools on the Host System
30 guided you through installing the Wind River Host Tools and Intelligent Device
Platform XT software on your Host System. With the software installed, you are now
ready to develop the applications and runtime operating system that will run on your
Target Device. This guide does not cover application development. For guidance, see
the documents listed in
This section explains how to build an Intelligent Device Platform XT runtime file
system and operating system. This runtime file system and operating system are built
on the Host System and then installed on the Target Device.
If you use Eclipse* or if you prefer a GUI-based development environment to build
your Target Device runtime file system and operating system, then see
Intelligent Device Platform Project Using Wind River Workbench
The steps in this section will take several hours to complete. If possible, begin these
steps at the end of the day and in a location that can be unattended so you can allow
the build process to run overnight.
What you need to do
Note: You may have used different directory names when you created directories in
Directories and Confirm Disk Space
the directory names in the following steps with the names of the directories you
created.
1. Begin this procedure in your
cd $HOME/Project
2. Use the Wind River Linux
command below for a typical
explore supported configuration options, and see the Wind River
Device Platform XT 2.0 – Programmer's Guide, Part II (Key Related Tasks) for help
with generating your own keys and for additional configuration options and details.
®
Intel IoT Gateway Development Kit DK200 Series
Getting Started Guide
38
Connect Connect Target Register Target
Hardware / Device to Host Device
Connect Target System
v
Device to Host
System
Reference Documents
Project
configure
configure
Build Runtime
Put Runtime
Install Linux and
on Host
Software on
Wind River
System
Flash Drive
Packages on
Host System
on page 12.
on page 23. If you used different names, replace
directory. Use the following command:
command to configure the build. See the
command. Use
Software
Install Runtime Update SPI
on Target Firmware on
Device Target Device
on page
Building an
on page 51.
Create
to
configure --help
®
Intelligent
April 2015
Order No.: 330295-004