Table of Contents
Advertisement
Register Your Development Kit—Intel IoT Gateway Development Kit DK200 Series
5.0
Register Your Development Kit
Important:
If you are using an Early Access Development Kit or a Loaner Development Kit from
the Intel Demo Depot, use the 90-day License Authorization Code provided in the
Dear Customer Letter that came with your kit. in this case, you do not need to register
your Target Device. Instead, skip ahead to
Linux Host Tools on the Host System
Before you
Begin
Before you begin the installation process, you must register your Development Kit.
The registration process submits a license key request to Wind River to permit you to
download Wind River Development software. You cannot use the Wind River installer
to download the Wind River software without this license.
You will use the login ID and password that you create or use in these steps to access
the Intel Registration Center. On the Intel Registration Center you can see a list of
licensed products and download the installers for those software products.
1. In your Web browser on any computer, go to
The following screen is displayed:
Figure 5.
Register a Product
April 2015
Order No.: 330295-004
Register
Connect
Connect Target
Target Device
Hardware /
Device to Host
Connect Target
System
Device to Host
System
Install Linux Packages and Wind River
on page 30.
Install Linux
Build Runtime
Put Runtime
and Wind River
on Host
Software on
Packages on
System
Flash Drive
Host System
https://registrationcenter.intel.com
®
Intel
IoT Gateway Development Kit DK200 Series
Install Runtime
Update SPI
on Target
Firmware on
Device
Target Device
Getting Started Guide
25
Advertisement
Table of Contents
