Table of Contents
Advertisement
Install Linux Packages and Wind River Linux Host Tools on the Host System—Intel IoT Gateway
Development Kit DK200 Series
Note:
You may have used different directory names when you created directories in
Directories and Confirm Disk Space
the directory names in the following steps with the names of the directories that you
created.
1. Copy the Installer file that you downloaded in
page 25, step 10 into the
2. Change to the
commands:
cd $HOME/Installer
unzip DVD*.zip
3. Start the Wind River Host Tools Installer with the following command:
./setup_linux
The Wind River Installer screen opens.
If instead you see the following screen indicating new Linux packages are
required, complete the steps below the figure.
Figure 12.
Wind River Installer Package Updates
a. To perform the updates, using the following command:
sudo apt-get install libstdc++6:i386 libgtk2.0-0:i386 libxtst6:i386
b. After the update command completes, repeat the
4. In the Installer window, select the Wind River Host Tools installation location.
The
WindRiver
select the
5. On the page Online Update Settings, perform the following actions:
•
If you are not using a proxy server to connect to the internet, go to step 7.
•
If your network requires a proxy server, check the box Connect to the
internet using a proxy server and provide your proxy information.
If you receive error messages, double-check your proxy settings and work with
your IT department for the appropriate settings.
April 2015
Order No.: 330295-004
on page 23. If you used different names, replace
$HOME/Installer
directory and unzip the installer file. Use the following
Installer
directory displays by default. If not, use the Browse button to
directory. Then click OK.
$HOME/WindRiver
Register Your Development Kit
directory.
./setup_linux
®
Intel
IoT Gateway Development Kit DK200 Series
Getting Started Guide
Create
on
command.
31
Advertisement
Table of Contents
