Step 4: Connect Klipsch System To The Tv's Input - Klipsch DVD Audio/Video System CS-700 Owner's Manual

STeP 4: Connect Klipsch System to the TV's Input

1.
If your TV doesn't have HDMI or COMPONENT, but has S-VIDEO,
connect S-VIDEO cable (not supplied) to the Klipsch system's
OUTPUT S-VIDEO jack and to the corresponding
2.
If your TV has COMPONENT INPUT jacks (Y, P
supplied) corresponding cables (either bundled or three separate
video grade cables—yellow) to the Klipsch system's
COMPONENT Y, P , P jacks and to the corresponding input jacks on
B R
the TV. To use this option, you must also connect the corresponding Y,
P , P OUTPUT to your TV.
B R
3.
If your TV doesn't have COMPONENT or S-VIDEO, connect the TV's
VIDEO INPUT (yellow) to the Klipsch system's
with the supplied cable.
TV BACK PANEL
COMPOSITE COMPONENT
INPUT 1 INPUT 2 INPUT 3
R R Y
L P
L
B
V V P
R
S-VIDEO
DIGITAL COAXIAL
OUTPUT
- OR -
2
3
1 OR
OR
S-VIDEO jack on the TV.
, P ) connect the (not
B R
VIDEO OUTPUT
COMPOSITE jack (yellow)
COMPONENT
AUDIO / VIDEO
OUTPUT OUTPUT
INPUT 4
Y Y R
P P L
B B
P V
P
R R
ANTENNA A ANTENNA B
DIGITAL OPTICAL
OUTPUT INPUT INPUT
4
5
4.
If your TV has an HDMI INPUT, connect the corresponding HDMI cable
VIDEO (not supplied) from the HDMI OUTPUT of the Klipsch system to the
HDMI INPUT of the TV.
5.
If you're using COMPONENT jacks or HDMI and your TV supports
progressive scanning technology (see the TV owner's manual if you
don't know whether your TV is a progressive scan TV), slide the
P.SCAN switch on the back of your Klipsch system to the
If you put the P.SCAN switch in the ON position and your TV doesn't
support progressive scan, you won't see a picture on the TV screen.
Note: until recently, tVs only had VIDeo INPut jacks. therefore, your tV
might not carry the "IN" or "Input" label even though it is an input.
Note: If an HDMI (digital) input is used to connect a source (such as a
cable or satellite box) to the CS-700, the tV must also be connected with
an HDMI cable to preserve the digital signal. Also, if an analog signal is
connected to the CS-700, the tV must also be connected with an analog
signal. the CS-700 will not up-convert an analog signal to a digital signal.
Please see appendix I (page 28) for the basics on how input
and output jacks work with your Klipsch system.
HDMI
INPUT
KLIPSCH CONTROLLER
Input and Output Jacks
ON position.