Step 3A: Set-Top Box Connection - Klipsch DVD Audio/Video System CS-700 Owner's Manual

STeP 3A: Set-Top Box Connection

Use this connection if your TV has a cable box, satellite receiver or HD receiver set-top box connected to it.
See next page (3B) if no set-top box is used.
CABLE BOX (shown)
HDMI OUT
KLIPSCH CONTROLLER
1.
Disconnect the cable on your cable, satellite or HD set-top box that is
connected to your TV (you need to connect 1 video and 1 audio).
2.
Connect the VIDEO—look at the options available on the set-top box
and choose 2A, 2B or 2C.
A. B. To maintain best picture quality—if the back of the set-top box
has HDMI or COMPONENT VIDEO
corresponding cable(s) into the jack(s) on the set-top box and to
the Klipsch system's
jacks (Y to Y; P to P
B
also connect the corresponding output from the Klipsch controller's
"VIDEO OUTPUT" section to your TV to ensure that you get a picture.
These cables have not been included with the Klipsch system.
When using the HDMI connections you must turn Progressive Scan
(P. SCAN) "On". If the HDMI connections are used and P. SCAN
is "Off", you will not see a picture.
C. If the set-top box has a VIDEO (yellow)
the supplied yellow video cable into that jack and to the Klipsch
system's SAT/CABLE/HD INPUT COMPOSITE
COMPONENT
Y P P
B R
- OR
OR
2A
2B
3A
(Y, P , P ) OUTPUT
B R
SAT/CABLE/HD INPUT HDMI or COMPONENT
, P to P ). If you use 2A or 2B, you must
B R R
OUTPUT jack for video, plug
(yellow) jack.
O U T P U T S
AUDIO
L R
VIDEO S-VIDEO
-
- OR -
2C
3B
3C
- OR -
3.
Connect the AUDIO—look at the options available on the set-top box
and choose 3A, 3B, 3C or 3D.
A.
If an HDMI cable is used, audio is already connected through this cable.
B.
Connect the supplied audio cables to the AUDIO LEFT (white) and
AUDIO RIGHT (red) jacks on the back of the set-top box and to the
Klipsch system's
jacks, plug
(red) jacks.
C.
If the set-top box has Digital AUDIO (COAXIAL), connect appropri-
ate cable to the set-top box AUDIO COAXIAL jack and to the
SAT/CABLE/HD INPUT COAXIAL
D.
If the set-top box has Digital AUDIO (OPTICAL), connect appropriate
cable (not supplied) to the Klipsch System's
OPTICAL
Note: If you connect a high definition Y, P
connect the corresponding Y, P
HDMI, you must also connect the corresponding output from the Klipsch
controller's "VIDeo outPut" section to your tV to ensure that you get a
picture. these cables have not been included with the Klipsch system.
Please see appendix I (page 28) for the basics on how input
and output jacks work with your Klipsch system.
CABLE SIGNAL
CABLE IN
DIGITAL
COAXIAL OPTICAL
3D
SAT/CABLE/HD INPUT LEFT
jack.
jack. You will first need to remove the plastic dust plug.
, P INPut, you must also
B R
, P outPut to your tV. If you connect a
B R
Input and Output Jacks
(white) and RIGHT
SAT/CABLE/HD INPUT