Replacing The Lens Using The Lens Change Table - Sony SRX-R510P Operating Instructions Manual

Lens flange
Shift base level
Check that there are no gaps
in each of the four locations
(including reverse side).
Replacing the Lens Using
the Lens Change Table
As an example, this section describes how to switch from
the 2D lens to the 3D lens. To switch from the 3D lens to
the 2D lens, perform the procedure in reverse.
1
Raise the stopper on the 2D lens table, and slide the
table until it is under the 2D lens.
2
Lower the stopper and slide it until it contacts the
inner side of the lens base.

Replacing the Lens Using the Lens Change Table

Stopper
Lens base
Stopper
31