Table of Contents
Advertisement
Starting the Projector
The projector can be started in the "Status – Auditorium"
screen.
1
In the "Status" screen, tap [Auditorium], and then tap
[Projector] in the [Control] pane.
The "Projector Control" screen will be displayed.
2
Tap [Power On] in [Power/Lamp].
The MAIN indicator on the rear of the projector will
turn solid green, and the LAMP indicator will blink
green.
Once the projector is on, the lamp will turn on, the
LAMP indicator will turn from a blinking to solid
green, and the three indicators (MAIN, LAMP, IMB)
will be solid green.
3
Tap [Close] to close the "Projector Control" screen.
The above procedures complete preparations and
confirmation for using the projection system.
Shutting Down the
System
1
Tap
on the upper right of the screen.
The following screen will be displayed.
2
Select [Shutdown], and then tap [OK].
The projection system will shut down.
The MAIN indicator and LAMP indicator on the rear
of the projector will turn to blinking green while
cooling. Once cooling is complete, the LAMP
indicator will turn to solid red. Leave the system as it
is at this point.
3
Once the MAIN and LAMP indicators turn solid red,
and the IMB indicator begins blinking red, move the
power switch to off (a) to turn off the power.
Caution
If, after shutdown, the power switch on the rear of the
projector is not turned off and only the server is turned on,
the IMB on the projector will not power on. If this happens,
the IMB indicator will blink red. Turn the power switch
off, and then turn the power on again.
13
Shutting Down the System
Hide quick links:
Advertisement
Table of Contents
