Advertisement
Fog Fury 1000
The new Fog Fury 1000 fog machine included a revolutionary new
heating element that has been specially designed to prevent exces-
sive particle build up that can cause premature fogger failure. Each
of the fog machines in this series include a wide-angle spray nozzle
and long-life pump that was specially designed for high performance
fogger output. The fog machine also includes a remote control, that
may be removed for periods on non-use. An optional wireless remote
control is also available from ADJ for the fog machine and increases
the functionality of the fogger greatly.
Fog Fury 1000
1. Open the shipping carton and carefully remove the unit from the
shipping carton.
2. Be sure to remove all the packing material especially around the
nozzle.
3. Set the fog machine on a flat dry surface. Locate the included
bracket from the package and install it using the supplied hard-
ware to the side casing. Note: The bracket is an optional accesso-
ry and may not be used if desired, however if you intend to sus-
pend the unit from truss the bracket must be used.
4. Fill the fog fluid reservoir with ADJ brand fog juice only and then
tighten the cap.
5. Firmly attach the remote control unit to the rear remote control
socket on the unit.
6. Plug the unit in to a matching power supply. At this time the fluid
reservoir will glow red, this indicates that the unit is heating up.
Wait about four minutes for the fogger to reach normal operating
temperature. When it has reached the temperature, the reservoir
will glow green.
7. Either press the remote button to emit fog or use the manual but-
ton on the rear of the unit to emit fog.
8. Follow the operating instructions on the next page for remote
operation.
ADJ Products, LLC - www.adj.com - Fog Fury 1000 Instruction Manual Page 4
Description
Fog Fury 1000
Always be sure to maintain an adequate supply of ADJ Brand
Fog Juice in the fluid reservoir. Running the fog machine dry will
cause pump failure and or clogging. This is the largest cause of
failure in fog and haze machines. Only ADJ Fog Juice is recom-
mended and not all fog juice is created equal.
Remote Operation:
machine. Once the machine is plugged in and turned on, a red power
LED on the remote will glow indicating the unit is receiving power.
The unit has a warm up time of about four (4) minutes. After the unit
has warmed up, a GREEN LED on the remote will light indicating the
Set-Up
unit is ready to emit fog. To emit fog, simply press the button on the
remote for desired length of time. If the GREEN LED is on and fog
does not come out after holding the button down for 30 seconds,
check the fluid tank and make sure you have enough fog juice.
Caution:
disconnect the power supply.
Start by connecting the remote to the fog
Before removing or replacing the remote control unit
ADJ Products, LLC - www.adj.com - Fog Fury 1000 Instruction Manual Page 5
Remote Operation
Advertisement
