Remote Operation - ADJ VF400 User Manual

This device features a revolutionary new heating element that has been specifically designed to
prevent excessive particle build up that can cause premature fogger failure. Additionally, this fog
machine has a wide-angle spray nozzle and a long-life pump, both of which have been specially de-
signed for high performance fogger output. A removable remote control device is also included.
1. Open the shipping carton and carefully remove the unit. Be sure to remove all the packing mate-
rial, paying particular attention to the area around the nozzle.
2. Set the machine on a flat dry surface. Remove the included bracket from the packaging and at-
tach it to the sides of the fog machine using the supplied hardware. Please note that the bracket
is easily detachable and is not required for table-top usage. However, when the device is installed
in a suspended environment, use of the bracket is required.
3. Fill the fog fluid reservoir with ADJ brand fog juice only, then replace the cap.
4. Firmly attach the remote control unit to the remote control socket located on the back of the unit.
5. Plug the unit into a power supply that meets the voltage requirements. A red LED on the remote
control will illuminate, indicating that the device is warming up. Once the device is warmed up,
a green LED will illuminate on the remote (the red LED should also remain illuminated). This indi-
cates that the unit is ready to emit fog.
6. Press the button on the remote to emit fog. Refer to the Remote Operation section of this man-
ual for detailed information.
Always be sure to maintain an adequate supply of ADJ® Brand Fog juice™ in the fluid reser-
voir. Running the fog machine dry will cause pump failure and/or clogging. This is the most
common cause of failure in fog machines.
Remote Operation: Start by connecting the VF400R remote to the fog machine. Once the machine
is plugged in and turned on, a red power LED on the remote will illuminate, indicating the unit is
receiving power. The unit has a warm up time of about five (5) minutes. After the unit has warmed up,
a green LED on the remote will illuminate, indicating the unit is ready to emit fog. To emit fog, simply
press and hold the button on the remote for desired length of time.
If the green LED is on and the unit does not emit fog after the button is pressed for 30 seconds,
check that the fluid tank has a sufficient amount of fog fluid.
Caution: Disconnect from the power supply before removing or replacing the remote control
unit.
DESCRIPTION
SET UP

REMOTE OPERATION

7