Remote Operation - ADJ VF1100 User Manual

1. Open the shipping carton and carefully remove the unit. Be sure to remove all the packing mate-
rial, paying particular attention to the area around the nozzle.
2. Set the machine on a flat dry surface. Remove the included bracket from the packaging and at-
tach it to the sides of the fog machine using the supplied hardware. Please note that although the
bracket is an optional accessory, its usage is required when the device is installed in a suspended
environment.
3. Fill the fog fluid reservoir with ADJ brand fog juice only, then replace and tighten the cap.
4. Firmly plug the remote control unit into the remote control socket located on the back of the unit.
5. Plug the unit into a power supply that meets the voltage requirements. The fluid reservoir will
glow red to indicate that the device is receiving power, and a green LED labeled "Heating" will
illuminate to indicate that the device is warming up, which should take about 2 minutes. When
the device has reached operating temperature, the "Heating" LED will turn off, and another LED
labeled "Ready" will illuminate to indicate that the device is ready to emit fog. Please note that
the reservoir will continue to glow red as long as the device is connected to power.
6. Press either the button on the remote or the manual button on the back of the device to emit fog.
Refer to the Remote Operation section of this manual for detailed information.
Always be sure to maintain an adequate supply of ADJ® Brand Fog juice™ in the fluid reser-
voir. Running the fog machine dry will cause pump failure and/or clogging. This is the most
common cause of failure in fog machines.
Remote Operation: Connect the VF5PR remote to the fog machine. Once the machine is plugged in
and turned on, the unit will require about 2 minutes to warm up. After the unit has reached operating
temperature, the green LED on the remote will illuminate, indicating that the unit is ready to emit fog.
To emit fog, simply press the button on the remote for desired length of time. If the green LED is on
and fog does not come out after holding the button down for 30 seconds, check the fluid tank and
verify that there is still fluid in the tank.
Caution: Before removing or replacing the remote control unit, disconnect the power supply.
Wireless Remote Operation: The VF1100 comes with an internal wireless receiver and wireless
remote (VFWR). To use the wireless remote, press button 1 on the remote when the fogger is ready
to emit fog.
SET UP

REMOTE OPERATION

7