Replacing The Yoke - Wyse WY-60 Maintenance Manual

4. If necessary, loosen the tension band tightening screw.
5.
Replace the four No.2 Phillips screws that secure the
assembly to the wire frame. Tighten.
6.
Replace the terminal PCB and insulator sheet.
7.
Make sure the tension band is tight.
it.
If it isn't, tighten
8.
Replace the back bezel, barrier plates, and keyboard cable.
9. Replace the terminal enclosure.
Removing and Replacing the Yoke
Tools required: None
To remove the yoke, follow these steps:
1. Remove the CRT/yoke assembly from the terminal.
2. Loosen the yoke lock on the neck of the CRT (see Figure 2-9).
3.
Remove t he yoke.
Figure
2-9
Replacing the Yoke
Yoke Lock
Yoke
! + - -
Crt Neck
2-15