Removing The Front Bezel; Service Action Allowed Indicator Led; Physical-Disk Drawers - Dell PowerVault MD3060e Owner's Manual

Storage enclosure

Hide thumbs Also See for PowerVault MD3060e:

Table of Contents

Figure 9. Removing and Installing the Front Bezel

release latches (2)

guide pins (4)

Removing The Front Bezel

You must remove the front bezel to access the disk drawers, which enables you to remove and install

physical disks in the system.

Press the release latch on either side of the front bezel.

Keeping the release latches pressed, hold the bezel and pull the bezel away from the system.

Each hot-swappable component on your storage enclosure has a Service action allowed indicator. The

Service action allowed indicator, indicates that a component can be safely removed from the storage

enclosure.

CAUTION: Never remove any hot-swappable component until the Service action allowed

indicator on the component lights blue. Removing a hot-swappable component with the Service

action allowed indicator off, can result in a loss of data and data availability.

NOTE: The Service action allowed indicator LED is not used in server attached configurations.

Each storage array contains five physical-disk drawers. Each physical-disk drawer supports up to 12 hot-

swappable physical disks.

NOTE: You can open only one physical-disk drawer at a time. If you attempt to open more than one

drawer, it may cause unexpected results.

front bezel

Table of Contents