Table of Contents
Advertisement
Message
Cause
The index sheet is
marked incorrectly.
The index sheet does
not match the photos on
the memory card.
An error occurred during
photo pre-scanning.
An error occurred during
film pre-scanning.
Not enough ink to
perform head cleaning.
There is a problem with
the Epson Stylus
CX7700.
A part on the Epson
Stylus CX7700 needs to
be replaced.
The waste ink pad is
nearly full.
The memory card does
not contain any valid
photos.
Memory card error.
The connected camera
is not recognized.
The paper thickness
lever is set to the wrong
position.
No memory card is
inserted.
Solution
Remove the index sheet, mark it
correctly, and try again; see page 22.
Remove the memory card and insert the
card used to print the index sheet—or
place the correct index sheet on the
document table. Then press x Start to
continue or y Stop/Clear Settings to
cancel.
Check that the photo is placed correctly
on the document table and try again; see
page 8.
Check that the film is placed correctly in
the film holder and on the document
table, and try again; see page 12.
Install new ink cartridges; see page 41.
Turn the Epson Stylus CX7700 off and
then back on. If the error does not clear,
contact Epson; see page 50.
Contact Epson; see page 50.
Contact Epson; see page 50.
Remove the memory card and check the
compatibility requirements on page 19.
Remove the memory card and check the
compatibility requirements on page 19.
Check the connection and try again; see
page 26.
Set the paper thickness lever to the
correct position and try again; see
page 7.
Insert a valid memory card and try again;
see page 19.
LCD Screen Messages
47
Advertisement
Table of Contents
