Making Prints From Slides Or Negatives; Placing 35Mm Slides In The Holder - Epson Stylus CX7700 Basic Manual

Making Prints From Slides or Negatives

You can use the film holder that came with your Epson Stylus CX7700 to scan
35mm slides, or strips of negative and positive film. To get professional results that
look and feel like traditional photos, try one of the special Epson papers listed on
page 34.
Before you scan and print see:
■
"Placing 35mm Slides in the Holder" (see below)
■
"Placing 35mm Film Strips in the Holder" on page 13

Placing 35mm Slides in the Holder

1. Open the document cover and remove the document mat. Pull up on the
fastener at the top of the document mat. Then pull out the mat.
2. Place the film holder's tabs into the two small holes at the left edge of the glass.
Make sure the cutouts for 35mm slides are toward the back of the glass to
align them with the fluorescent lamp when you close the document cover.
12
Copying a Photo or Document
Fluorescent lamp