Table of Contents
Advertisement
BD Pro Series
The Load and Copy setting will load the master to the hard drive during the first burn cycle;
subsequent burns without leaving Copy mode or changing the master disc will use the hard drive
image as the source for added stability.
If you need to change masters when the Duplication Mode is set to Load and Copy, you must
return to the main 1. Copy menu.
The Prompt setting will ask you to specify Load and Copy or On the Fly when the Copy button is
pressed.
The On the Fly setting will use the loaded master disc in the reader drive as the source at all
times.
Counter
Use the Counter menu to enable or disable the Counter feature. The counter tells you how many
discs have copied and how many discs are left to go during the duplication process stopping the
job once the desired number of copies has been made.
DVD+R High Compatibility Mode
This feature allows you to turn the DVD+R High Compatibility Mode feature ON or OFF. The
purpose of this feature is to increase the compatibility of DVD+R media with a broader range of
DVD Video players.
ISRC
This option will allow you to enable/disable copying the ISRC code of an Audio CD. ISRC is the
serial number of the audio track that uniquely identifies the song in that audio track. This ISRC
code is commonly found in commercial Audio CDs and rarely seen on home made Audio CDs. By
enabling this feature, the duplication performance will be lowered.
Disable Drives
Use this utility to allow the system to disable certain drives/trays when certain drives/trays are
producing high failure rates.
External Connection
The BD Pro Series Duplicators include a USB connection that allows you to use the hard drive as
an external drive connected to your PC. The BD Pro Series also includes an optional Ethernet
connection.
Use this setting to enable one drive in the duplicator to be used as an external drive connected to
your PC through a USB 2.0 connection or with the optional Ethernet connection.
Select the Setup menu and use the ▼▲ buttons and press the ENT button the display reads
External Connection. If the display indicates that the connection is OFF, use either arrow key to
change the setting to ON, then press ENT to save the setting. The duplicator will be briefly
unresponsive as the hard drive is released from duplication mode. Press ESC to leave the Setup
menu.
Please note that while the External Connection setting is ON, the connected drive will be
unavailable to the duplicator.
Overburn
This feature allows you to turn the ability to use the overburn area ON or OFF. Only CD-RW and
BD-RE burning will be affected by this setting.
Overburning is the process of recording data past the normal capacity limit. Many disc
manufacturers extend a recordable disc to leave a small margin of extra data surface at the outer
edge.
Turning this feature ON allows rewritable media to be burned out to the full capacity, using the
otherwise reserved areas of the media for data storage.
It is recommended that this setting be left OFF unless it is absolutely necessary for your
masters to copy to your blank media, as only the reported normal capacity of the media
can be guaranteed.
There may be variations in the total available capacity between
individual discs that can result in inconsistent burn success.
17
Advertisement
Table of Contents
