Assembly; Fitting The Handguard And Loop Handle; Fitting The Cutting Head - Husqvarna 300-SERIES COUPLING Operator's Manual

Fitting the hand guard and
loop handle
S Loosen the clutch sleeve's two mounting
bolts and dismantle the clutch sleeve.
S Assemble the hand guard and loop han-
dle by screwing them together. Make
sure the holes in both parts are aligned.
S Slide the loop handle and hand guard
onto the shaft.
S Slide the spacer into the slot in the loop
handle.
S Install the nut and screw. Do not over-
tighten.
S Now make a final adjustment to give
yourself a comfortable working position.
Tighten the screw.
CAUTION! The loop handle and hand
guard must not be fitted behind the arrow
marked on the shaft.
115289826 Rev. 2 4/27/10

ASSEMBLY

S Reinstall the clutch sleeve and tighten
the two mounting bolts.
itting the cutting head
F
It is important that the hedge trimmer is
laid on a flat surface when you attach the
cutting head. Otherwise the cutting head
may not be attached straight.
S Fit the cutting head to the shaft.
CAUTION! Make sure the drive shaft in-
side the shaft engages with the recess in
the cutting head.
S Tighten the lower screw first, then the
upper screw.
English--- 6