Husqvarna 300-SERIES COUPLING Operator's Manual
Husqvarna 300-SERIES COUPLING Operator's Manual

Husqvarna 300-SERIES COUPLING Operator's Manual

Hedge trimmer attachment

Advertisement

300-SERIES COUPLING 300-
SERIES COUPLING 300-SERI
ES COUPLING 300-SERIES C
OUPLING 300-SERIES COUP
LING 300-SERIES COUPLING
300-SERIES COUPLING 300-
SERIES COUPLING 300-SERI
ES COUPLING 300-SERIES C
OUPLING 300-SERIES COUP
LING
300-SERIES COUPLING
300-SERIES COUPLING 300-
SERIES COUPLING 300-SERI

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 300-SERIES COUPLING and is the answer not in the manual?

Questions and answers

Summary of Contents for Husqvarna 300-SERIES COUPLING

  • Page 1 300-SERIES COUPLING 300- SERIES COUPLING 300-SERI ES COUPLING 300-SERIES C OUPLING 300-SERIES COUP LING 300-SERIES COUPLING 300-SERIES COUPLING 300- SERIES COUPLING 300-SERI ES COUPLING 300-SERIES C OUPLING 300-SERIES COUP LING 300-SERIES COUPLING 300-SERIES COUPLING 300- SERIES COUPLING 300-SERI...
  • Page 2: Table Of Contents

    Contents ......Husqvarna AB has a policy of continuous Note the following before starting ..
  • Page 3: Key To Symbols

    KEY TO SYMBOLS Symbols Noise emission to the environment according to the European Community’s WARNING: Incorrect or careless Directive. The machine’s use of a hedge trimmer can turn it emission is specified in the into a dangerous tool that can Technical data section and cause serious or even fatal injury.
  • Page 4: What Is What

    WHAT IS WHAT? What is what on the hedge trimmer attachment? 1. Cutter Hand guard 2. Grease plugs for adding Shaft coupling lubricant Shaft 3. Bevel gear Hex wrench 4. Front handle 10. Transport guard 5. Hand guard mounting screw 11. Operator’s manual 115289826 Rev.
  • Page 5: Safety Instructions

    SAFETY INSTRUCTIONS Machine’s safety equipment Hand guard This section describes the machine’s safety equipment, its purpose, and how checks and maintenance should be carried out to ensure that it operates correctly. See the “Know your The hand guard prevents hands from com- trimmer ”...
  • Page 6: Assembly

    ASSEMBLY Fitting the hand guard and S Reinstall the clutch sleeve and tighten the two mounting bolts. loop handle S Loosen the clutch sleeve’s two mounting bolts and dismantle the clutch sleeve. itting the cutting head It is important that the hedge trimmer is S Assemble the hand guard and loop han- laid on a flat surface when you attach the dle by screwing them together.
  • Page 7: Starting And Stopping

    STARTING AND STOPPING Check before starting S Inspect the working area. Remove any objects that could be thrown out. S Check the cutting attachment. Never use blades that are dull, cracked or dam- aged. S Check that the machine is in perfect working order.
  • Page 8: Working Techniques

    WORKING TECHNIQUES General working instructions EYE PROTECTION Always wear approved eye protection. If IMPORTANT! you use a visor then you must also wear This section takes up the basic safety pre- approved protective goggles. Approved cautions for working with a hedge trimmer. protective goggles must comply with with If you encounter a situation where you are standard ANSI Z87.1 in the USA or...
  • Page 9 WORKING TECHNIQUES Safety instructions regarding the S When the engine is switched off, keep your hands and feet away from the surroundings cutting attachment until it has stopped S Never allow children to use the machine. completely. S Ensure that no- -one comes closer than S Watch out for stumps of branches that 50 feet (15 meters) while you are can be thrown out during cutting.
  • Page 10 WORKING TECHNIQUES Basic working techniques S Work with a swinging action from the bottom upwards when trimming sides. S Adjust the throttle setting to suit the load. S When trimming a hedge the engine should always face away from the hedge.
  • Page 11: Maintenance

    20 hours of operation, and subsequently approximately every 60 hours of operation. Use Husqvarna’s special grease, no. 503 98 96-01. S Check that the blades do not move when the engine is idling or when the choke is in the start throttle position.
  • Page 12: Ec Declaration Of Conformity

    DECLARATION OF CONFORMITY EC Declaration of Conformity (Only applies to Europe) We, Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46- -36- -146500, as authorised representative in the Community, declare that this hedge trimmer attachment with serial numbers dating from 2009 and onwards (the year is clearly stated on the rating plate, followed by the serial number), comply with the requirements of the COUNCIL’S DIRECTIVES:...

Table of Contents