Sony KF-50SX200 Service Manual page 144

NexTView
Using the Long Info menu
1
2
To set the timer
Push the joystick
button repeatedly to "set the timer" or "cancel the timer". If you choose
to set the timer, the programme is marked with a clock symbol and a
message appears on the screen shortly before the programme is due
to start asking whether you wish to still view this programme.
To view the timer table
Push the joystick
button repeatedly to switch on/off the timer table. This table shows the
programmes on which you have already set a timer. (You can set a timer
on up to 5 programmes).
To record programmes
(only with Smartlink VCRs)
1
2
3
4
With this menu screen, you can set timers or record selected
programmes.
Push or to select a future programme in the programme list
column.
Press the button to display the Long Info menu on the TV
screen.
or to highlight the
or to highlight the
Connect your Smartlink VCR.
Push the joystick or to select
to download the information to your VCR.
To set up the VCR:
VPS/PDC
Push the joystick or to select VPS/PDC then press the
button repeatedly to select On or Off. With this setting on you have
the guaranteed recording of the whole broadcast should there be a
change in the TV programme. This only works if the selected
channel broadcasts a VPS/PDC signal.
Speed
Push the joystick to select Speed then press the
repeatedly to select between SP for standardplay or LP for longplay.
With longplay you can record twice as much on a videotape.
The picture quality however may suffer.
VCR Setup
Push the joystick to select VCR Setup then press the
button repeatedly to select which VCR you wish to programme,
namely VCR1 or VCR2.
Finally, push the joystick
button to remove the menu from the TV screen.
icon then press the
icon then press the
then press the
button
to select the icon then press the
First nextTView/EPG-Providers in Europe
07 Tue
SWISS TXT
12:38
Address Mapping
The position of the addresses in the
OSDA is shown in the following diagram.
The position values of the DPW are set
to '0'.
If other values are set, the complete
combination will be scrolled.
Example:
if the DPWC is set to '63', the char-
This channel has been set for a timer
VPS/PDC On
Speed SP
Timer Prog VCR1
button
VPS/PDC
Speed
VCR Setup VCR1
NexTView
TPS / RINGIER nexTView
Tue 07. 04 .98
GB
On
SP
29