3.3.6 Printer unit
(1)
Remove the upper cover.(See. 3.3.4)
(2)
Disconnect the two head cables, homing sensor cable, SP motor cable, LF motor cable,
gap sensor cable, and PE sensor cable from the connectors.
Remove the four mechanical locking screws 1.
(3)
(4)
Lift up and remove the printer unit 2.
(5)
Assemble in the reverse order of disassembly.
Notes :
(1) Take care not to fold the carriage cable during installation. Curre slightly the carriage
cable when assembling into the fastenera.
(2) Make sure that there is not any dust or oil on the connector contact sectious A.
If it is found,wipe it off by alcohol.
2
43471801TH Rev.1
1
Oki Data CONFIDENTIAL
37 /