Download Print this page

Britax KID XP User Instructions page 2

Advertisement

PAGE II
7. SAFETY NOTES
Please take the time to read these instructions carefully and keep
them to hand in the intended storage compartment
06
on the child
safety seat at all times! The instructions must be with the child safety
seat if the latter is passed on to a third party.
DANGER! For the protection of your child:
• In the event of an accident with a collision speed of more than 10 km/h, the
child safety seat may be damaged without the damage becoming imme-
diately visible. In this case the child safety seat must be replaced. Please
dispose of it properly.
• Have your child safety seat checked as a rule if it was damaged (e.g if it
falls to the ground).
• Regularly check all important parts for damage. Ensure that all mechanical
parts, in particular, are fully functional.
• Never lubricate or oil parts of the child seat.
• Never leave your child unattended in the child seat in the vehicle.
• Let your child in and out of the vehicle from the pavement side as a rule.
• Protect the child safety seat against intensive direct sun radiation,
as long as it is not in use. The child safety seat can become very hot
under direct sun radiation. Child skin is sensitive and could thereby
be injured.
• The more snugly the harness fits over your child's body, the better your will be
protected. Therefore avoid putting thick clothes on your child under the belt.
• Take regular breaks on long journeys in order to give your child the opportu-
nity to play around.
• Use on the rear seat: Push the front seat forwards sufficiently so that the
feet of your child do cannot hit the backrest of the front seat (to avoid the
risk of injury).
DANGER! For the protection of all vehicle occupants:
In the case of an emergency stop or an accident, unsecured persons or
objects may cause injury to other vehicle occupants. Please always check
that...
• the backrests of the vehicle seats are locked (i.e. that a foldable rear seat
bench latch is engaged).
• all heavy or sharp-edged objects in the vehicle (e.g. on the parcel shelf) are
secured.
• all persons in the vehicle have their seatbelts fastened.
• the child safety seat is always secured when it is in the vehicle, even if no
child is being transported.
WARNING! For your protection when handling the child seat:
• Never use the child safety seat free-standing, not even for test sitting.
• When swivelling up the backrest
, nothing must come between the back-
07
rest
and the seat cushion
. You or your child could pinch your fingers,
07
03
injuring them.
• To avoid damage, ensure that the child safety seat is not jammed in between
hard objects (car door, seat rails, etc.).
• Keep the child safety seat in a safe place if it is not in use. Do not place any
heavy objects on the seat and do not store it directly next to sources of heat or
in direct sunlight.
CAUTION! To protect your vehicle:
• Certain car seat covers made from more sensitive materials (e.g. velour, leath-
er, etc.) may sustain signs of wear and tear when using child safety seats. For the
optimum protection of your car seat covers, we recommend using the BRITAX
RÖMER child safety seat surface from our accessories programme.
8. ADJUSTING THE HEADREST
A correctly set headrest
22
ensures that the diagonal seat belt section
optimally positioned, and gives your child optimum protection.
The headrest
must be adjusted so that there is a space two fingers wide
22
between the headrest
22
and your child's shoulders.
To adjust the height of the headrest to fit your child:
1. Reach into the adjustment handle
05
on the back of
05
22
the headrest
and pull it towards you.
22
This unlocks the headrest.
2. You can now move the unlocked headrest
the desired height. As soon as you release the
adjustment handle
05
, the headrest
22
into place.
3. Place the child safety seat on the vehicle seat.
22
4. Have your child sit down in the child safety seat and
check the height. Repeat the procedure until the
headrest
22
has the correct height.
140901_KID_XP_GB.indd 2
9. INSTALLATION
With 3-point belt
The
is not installed permanently in the vehicle. It is simply secured
KID XP
together with your child using the vehicle's 3-point seatbelt.
1. Carry out the steps in Section 8 „ADJUSTING THE
HEADREST".
2. Place the XP-PAD
04
on the side of the child safety
seat closer to the vehicle door.
3. Guide the elastic holding strap of the XP-PAD
into the dark red belt holder
04
until it lies completely in the belt holder
not twisted.
07
4. Place the child seat on the vehicle seat. Ensure that
the backrest
is flush with the backrest of the
07
vehicle seat.
TIP! If the headrest of the vehicle seat gets in the
way, turn it the other way.
01
5. Carry out the steps in Section 10 „SECURING
04
YOUR CHILD".
10. SECURING YOUR CHILD
1. Let your child sit in the child safety seat and place
the XP-PAD
04
over the chest area of your child.
2. Pull out the vehicle belt and guide it in front of your
child to the vehicle seat buckle
04
DANGER! Ensure the vehicle belt is not twisted, as
otherwise the full protective effect of the
retaining system is not ensured.
3. Engage the buckle tongue in the vehicle seat buckle
18
with a CLICK!
18
4. Place the diagonal seat belt section
16
is
belt section
15
on the side of the vehicle seatbelt
16
buckle
into the light red belt guide
18
cushion.
15
02
DANGER! The vehicle seatbelt buckle
not be positioned between the light red
belt guide
02
18
5. Also place the lap belt section
of the seat cushion in the light red belt guide
22
to
DANGER! The lap belt section
as possible over your child's hips on
will lock
02
both sides.
15
6. Guide the diagonal seat belt section
16
22
red belt holder
completely in the belt holder
TIP! If the backrest
01
you can adjust the headrest
seat belt section
return the headrest
7. Ensure that the diagonal belt
16
collarbone of your child and is not on the neck and
that the key on the belt holder is
TIP! You can still adjust the height of the headrest
22
again here in the vehicle.
01
04
8. Open the Velcro fastener on the XP-PAD
01
of the headrest
fold the top part of the XP-PAD
01
and is
16
9. Insert the diagonal belt
04
of the XP-PAD
10. Close the XP-PAD
part back and closing the Velcro fastener.
DANGER! The diagonal seat belt section
16
DANGER! The diagonal belt
11. Tighten the vehicle seat belt by pulling on the diag-
16
onal seat belt section
For the safety of your child, before every journey in the car check
that...
►the child safety seat is securely fastened;
15
►the lap belt
runs in the bright red belt guides on both sides of the seat
cushion
,
02
►the diagonal seat belt section
16
.
18
le
also runs through the light red belt guide
18
►the diagonal seat belt section
16
of the headrest,
►the diagonal seat belt section
16
►the straps are tight and not twisted,
►the XP-PAD
is installed and used correctly,
04
►the seatbelt buckle
18
must not be positioned on the red belt guide
the seat cushion.
DANGER! If your child tries to open the vehicle belt buckle
immediately as soon as possible. Check whether the child safety seat is
correctly fastened and ensure that your child is correctly secured. Explain
to your child the dangers associated with his actions.
UNFASTENING YOUR CHILD AND REMOVAL:
and lap
16
To unfasten your child or to remove the child safety seat, observe the
steps in Section 6 „REMOVAL" [PAGE I]
of the seat
02
18
must
and the armrest.
15
on the other side
02
.
If you have any further questions regarding its use, please feel free to contact
must lie as low
15
us:
BRITAX RÖMER
Kindersicherheit GmbH
Blaubeurer Straße 71
D-89077 Ulm
Germany
BRITAX EXCELSIOR
LIMITED
1 Churchill Way West
Andover
Hampshire SP10 3UW
United Kingdom
16
into the dark
of the headrest
until it lies
01
22
01
and is not twisted.
07
conceals the belt holder
,
01
upwards. The diagonal
22
16
can now be easily inserted. Now
to the proper height.
22
16
runs over the
fully closed.
01
04
and
to the side.
04
16
in the die nubby surface
.
04
04
again by folding the folded
must
16
run diagonally backward. You can
adjust the course of the belt with your
vehicle's adjustable belt deflector.
16
must never be
directed forwards to the belt deflector on
the vehicle. In this case, use the child
safety seat on the back seat only.
16
.
on the side of the vehicle seatbelt buck-
02
of the seat cushion,
runs through the dark red belt holder
01
runs diagonally backward,
02
in
, stop
18
T.: +49 (0) 731 9345-199
F.: +49 (0) 731 9345-210
E.: info@de.britaxeurope.com
www.roemer.eu
T.: +44 (0) 1264 333343
F.: +44 (0) 1264 334146
E.: service.uk@britax.com
www.britax.eu
02.09.2014 14:37:54

Advertisement

loading