Winnebago Travato User Manual page 67

Leave the Water Heater Bypass valve handle
in NORMAL FLOW position if draining water
and blowing out waterlines. Place in BYPASS
position ONLY when using antifreeze solution in
waterlines.
WA RNING
NEVER use automotive antifreeze/
coolant in your RV water system.
Automotive coolant/antifreeze contains
ethylene glycol which, if ingested, can
cause blindness and can be fatal.
Remove Water Filters (if equipped)
1. Remove and discard the filter cartridge from
the cold water filter assembly below the galley
sink. (If your coach is not equipped with
filtered cold water, proceed to next numbered
step).
• Place a container beneath the filter to catch
any water remaining in the waterlines during
filter removal.
• Twist the filter cartridge counter-clockwise
(to the left) about one-quarter turn, then pull
it down and out of the filter socket.
• Install the diverter plug into the filter socket.
Insert plug up into the filter socket as far as
possible and twist clockwise (to the right)
one-quarter turn until it stops.
Set Up Winterization Valves
2. Turn the Water Heater Bypass valve to
BYPASS position. (See "Water System Drain
Valve Locations" chart at the end of this
section for location on your model).
Water Heater Bypass Valve
-Typical installation shown
(See "Water System Drain Valve Locations" chart
at the end of this section for location on your model)
3. Insert the end of the siphon tube (located at
front of galley behind access door) into a pail
or other container with 2 to 3 gallons of non-
toxic RV antifreeze solution.
SECTION 7 –
PLUMBING
7-15