Configuring Upnp Settings - HIKVISION E Series User Manual

User Manual of E Series 5 Inch Network Speed Dome
2. Configure the FTP settings, including server address, port, user name, password,
directory and upload type.

Setting the directory in FTP server for saving files:
In the Directory Structure field, you can select the root directory, parent
directory and child directory.
 Root directory: The files will be saved in the root of FTP server.
 Parent directory: The files will be saved in a folder in FTP server. The
name of folder can be defined as shown in following Figure 6-20.
 Child directory: It is a sub-folder which can be created in the parent
directory. The files will be saved in a sub-folder in FTP server. The name of
folder can be defined as shown in following Figure 6-21.

Upload type: To enable uploading the captured picture to the FTP server.
3. Click
Note: If you want to upload the captured pictures to FTP server, you also have to
enable the continuous snapshot or event-triggered snapshot in Snapshot
interface. For detailed information, please refer to the Section 6.6.8 Configuring
Snapshot Settings.

6.3.9 Configuring UPnP Settings

Universal Plug and Play (UPnP) is a networking architecture that provides
compatibility among networking equipment, software and other hardware devices.
With the UPnP function enabled, you don't need to configure the port mapping for
each port, and the camera is connected to the Wide Area Network via the router.
Steps:
1. Enter the UPnP settings interface.
Configuration >Advanced Configuration > Network > UPnP
2. Add a Friendly Name and check the Enable Port Mapping checkbox.
3. Select the Port Mapping Mode as Auto or Manual.
4. If in Manual mode, you can check the checkbox of HTTP, RTSP or SDK port
according to your demand.
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
Figure 6-20 Parent Directory
Figure 6-21 Child Directory
to save the settings.
42