Configuring Upnp™ Settings; Configuring Nat (Network Address Translation) Settings - HIKVISION e series User Manual

User Manual of E Series Network Speed Dome
 Upload type: To enable uploading the captured picture to the FTP server.
3. Click to save the settings.
4. You can click Test to confirm the configuration.
If you want to upload the captured pictures to FTP server, you also have to enable the
continuous snapshot or event-triggered snapshot in Snapshot interface. For detailed
information, please refer to the Section 7.3 Configuring Snapshot Settings.
6.3.9 Configuring UPnP™ Settings
Universal Plug and Play (UPnP™) is a networking architecture that provides compatibility among
networking equipment, software and other hardware devices. The UPnP protocol allows devices
to connect seamlessly and to simplify the implementation of networks in the house and
corporate environments.
With the function enabled, you don't need to configure the port mapping for each port, and the
camera is connected to the Wide Area Network via the router.
Steps:
1. Enter the UPnP™ settings interface.
Configuration >Advanced Configuration > Network > UPnP
2. Check the checkbox to enable the UPnP™ function.
You can edit the Friendly Name of the speed dome. This name can be detected by
corresponding device, such as a router.

6.3.10 Configuring NAT (Network Address Translation) Settings

Steps:
1. Set the port mapping mode:
To port mapping with the default port numbers:
Choose
To port mapping with the customized port numbers:
Choose
© Hikvision
Figure 6-21 Child Directory
Figure 6-22 Configure UPnP Settings
45