Toshiba Qosmio X300 Series User Manual page 181

2
The computer stops working (hangs) when you insert an
ExpressCard
The problem may be caused by an I/O (input/output) conflict
between the socket and another device in the system. Use Device
Manager to make sure each device has its own I/O base address.
See
information.
Since all ExpressCards
required to have its own address.
Hot swapping (removing one ExpressCard
another without turning the computer off) fails.
Follow this procedure before you remove an ExpressCard
1
2
3
4
The system does not recognize your ExpressCard
Refer to the ExpressCard
Removing a malfunctioning card and reinstalling it can correct
many problems.
Downloaded from LpManual.com Manuals
Double-click the appropriate ExpressCard, which will be listed
under one of the categories shown, for example: Disk drives,
Network adapters, Other, etc.
The operating system displays your ExpressCard's Properties
dialog box, which contains information about your
ExpressCard configuration and status.
®
.
"Fixing a problem with Device Manager" on page 171
Click the Safely Remove Hardware icon in the Notification
Area.
The Safely Remove Hardware screen appears.
Click Safely remove for the device you want to swap.
Select the item you wish to remove and click OK.
Remove the device when told it is safe to do so.
Never swap modules when the computer is in Hibernation or Sleep
mode. This is known as "warm swapping" and is not supported. For
more information on Hibernation and Sleep modes see
mode" on page 78
If Something Goes Wrong
Resolving a hardware conflict
®
share the same socket, each card is not
and "Sleep mode" on page
®
documentation.
181
for more
®
and inserting
®
:
"Hibernation
78.
®
.