Parkview® Rear Back-Up Camera; Power Sliding Rear Window - RAM 1500 2014 User Manual

Cleaning The ParkSense® Sensors
If "CLEAN PARK ASSIST SENSORS" appears in the Electronic Vehicle Information
Center (EVIC), clean the ParkSense
cloth. Do not use rough or hard cloths. Do not scratch or poke the sensors. Otherwise,
you could damage the sensors.
NOTE:
When the Instrument Cluster reads either Clean Sensor or Blinded, please clean off
the bumper sensors to see if the condition is corrected.
PARKVIEW® REAR BACK-UP CAMERA
• You can see an on-screen image of the rear surroundings of your vehicle whenever
the shift lever is put into REVERSE. The ParkView
will be displayed in the rearview mirror or touchscreen display along with a caution
note to "check entire surroundings" across the top of the screen. After five seconds
this note will disappear.
• If the rearview mirror or touchscreen display appears foggy, clean the ParkView
camera located to the left of the tailgate handle.
Drivers must be careful when backing up; even when using the ParkView
Back-Up Camera. Always check carefully behind your vehicle, and be sure to
check for pedestrians, animals, other vehicles, obstructions, or blind spots before
backing up. You must continue to pay attention while backing up. Failure to do so
can result in serious injury or death.

POWER SLIDING REAR WINDOW

The switch for the power sliding rear window is located on the overhead console.
• Push the switch right to open the glass
and pull the switch left to close the
glass.
OPERATING YOUR VEHICLE
sensors with water, car wash soap and a soft
®
WARNING!
® Rear Back-Up Camera image
®
® Rear
47