RAM 1500 2014 User Manual page 124

ELECTRONICS
Programming A Non-Rolling Code
NOTE:
For programming Garage Door Openers manufactured before 1995.
1. Turn the ignition switch to the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink
button you wish to program while keeping the HomeLink
3. Simultaneously press and hold both the HomeLink
and the hand-held transmitter button.
4. Continue to hold buttons until the EVIC display changes from "CHANNEL #
TRAINING" to "CHANNEL # TRAINED", then release both buttons.
5. Press and hold the programmed HomeLink
light.
NOTE:
If the EVIC displays "DID NOT TRAIN" repeat from Step 2.
• To program the two remaining HomeLink
remaining button. DO NOT erase the channels.
Using HomeLink®
To operate, press and release the programmed HomeLink
now occur for the programmed device (i.e., garage door opener, gate operator,
security system, entry door lock, home/office lighting, etc.,). The hand-held trans-
mitter of the device may also be used at any time.
• Your motorized door or gate will open and close while you are programming the
universal transceiver. Do not program the transceiver if people or pets are in the
path of the door or gate.
• Do not run your vehicle in a closed garage or confined area while programming
the transceiver. Exhaust gas from your vehicle contains Carbon Monoxide (CO)
which is odorless and colorless. Carbon Monoxide is poisonous when inhaled
and can cause you and others to be severely injured or killed.
122
® button and observe the indicator
® buttons, repeat each step for each
WARNING!
® indicator light in view.
® button you want to program
button. Activation will
®
®