Table of Contents
Advertisement
3.8 Resetting to the factory default settings
To reset the Network Camera to the original factory settings, go to the Setup>System> Maintenance
web page (described in "3.5.6 System > Maintenance") or use the Reset Button on the network
camera, as described below:
•
Using the Reset Button
Follow the instructions below to reset the Network Camera to the factory default settings using
the Reset Button.
1.
Switch off the Network Camera by disconnecting the power adapter.
2.
Press and hold the Reset Button with a straightened paperclip while reconnecting the power.
3.
Keep the Reset Button pressed until the Status indicator blink.
4.
Release the Reset Button.
5.
When the Power Indicator changes to Green (may take up to 40 seconds), the process
is complete and the network video camera has been reset.
6. The network camera resets to factory defaults and restarts after completing the factory reset.
CAUTION: When performing a Factory Reset, you will lose any settings you have saved.
72
Advertisement
Table of Contents
