Table of Contents
Advertisement
3.5 Network Camera Setup
This section describes how to configure the network camera, and is intended for product
Administrators, who have unrestricted access to all the Setup tools; and Operators, who have access
to the settings for Basic, Live View, Video & Image, Event, and System Configuration.
You can configure the network camera by clicking Setup in the top right-hand corner of the Live View
page. Click on this page to access the online help that explains the setup tools
When accessing the Network Camera for the first time, the
"Admin Password" dialog appears. Enter your admin name
and password, set by the administrator.
Note: If the password is lost, the Network Camera must
be reset to the factory default settings.
See "3.6 Resetting to the Factory Default Settings".
3.6 Resetting to the factory default settings
To reset the Network Camera to the original factory settings, go to the Setup>System >Maintenance
web page (described in "3.5.4 System>Maintenance" of the User's Manual) or use the control button
on the network camera, as described below:
Follow the instructions below to reset the Network Camera to the factory default settings using the
Reset Button.
1.
Switch off the Network Camera by disconnecting the power adapter.
2.
Open the lens cover.
3.
Press and hold the Control Button (SW1) on the board with your finger while reconnecting
the power.
4.
Keep the Control button (SW1) pressed during about 2 seconds.
5.
Release the Control Button (SW1).
6.
The network
camera
7.
Close the lens cover.
CAUTION: When performing a Factory Reset, you will lose any settings you have saved.
3.7 More Information
For more information, please see the Network Camera User's Manual, which is available on the CD
included in this package.
resets to factory defaults and restarts after completing the factory reset.
HNG-D312S, Quick Installation Guide
8
Advertisement
Table of Contents
