1B5-4 SD-709 AIR CONDITIONING COMPRESSOR
J 29886
J 37795
Figure 8—Removing the Bearing
• Turn the puller center bolt to the right with a
socket wrench until the rotor pulley is free (fig
ure 7).
6. Rotor bearing.
• Remove the snap ring from the rotor.
• Place the rotor in a vise.
• Install J 37795 and J 29886.
• Tap the bearing (6) out (figure 8).
7. Field coil (10).
• Loosen the coil lead wire from the clip on top of
the compressor front housing.
• Remove the snap ring (7) (figure 9).
• Remove the coil.
SHAFT SEAL
Always replace the shaft seal assembly if it is disassem
bled. Never reuse any of the old parts.
To service the shaft seal without disassembling the
clutch, perform steps 1 and 2 under " Clutch" and then
proceed as follows.
Remove or Disconnect (Figures 2 and 10 through
4~f
12)
Tools Required:
J 9553-01 O-Ring Hook
J 37793 Seal Seat Remover/Installer
J 37794 Shaft Seal Remover and Installer
Clutch shims (3) using J 9553-01 and a small screw
1.
driver.
2.
Felt ring metal retainer (25).
• Insert the points of a snap ring pliers into the
holes in the retainer and lift out (figure 10).
Shaft seal seat snap ring.
3.
Shaft seal seat (23) with J 37793 (figure 11).
5.
Seal assembly.
• Press J 37794 against the seal spring and twist
the tool until it engages the slots of the seal
cage (figure 12).
F-06174
Figure 9—Removing the Coil Snap Ring
SHAFT SEAL
-► 4- Install or Connect (Figures 2,11 and 13)
Tools Required:
J 29640 Shaft Protector
J 37794 Shaft Seal Remover and Installer
J 37793 Seal Seat Remover/Installer
Clean
Seal cavity thoroughly.
a. Use R-12 refrigerant. Blow dry.
b. Wipe with a lint free cloth and clean refrigerant
oil. Blow dry.
J 29640 over the compressor shaft.
• Do not touch the new seal lapping surfaces. Dip
the mating surfaces in clean refrigerant oil.
Slots of J 37794 to the new seal cage (21).
Seal assembly into place in the compressor seal cav
ity (figure 13).
• Twist J 37794 to disengage it from the cage.
Clean refrigerant oil to the shaft seal seat.
Shaft seal seat (23) with J 37793 (figure 11).
Snap ring with the flat side toward the compressor.
Clutch spacer shims (3).
Use the originals if possible to give the same gap.
New felt ring.
• If the clutch was not disassembled, reinstall the
clutch front plate.
CLUTCH
-► 4- Install or Connect (Figures 2 ,3 ,1 4 and 15)
Tools Required:
J 37795 Bearing Remover and Installer/Pulley
Installer
ASSEMBLY OF THE
CLUTCH AND
SHAFT SEAL