1B1-20 A-6 AIR CONDITIONING COMPRESSOR
16. Front Head
17. Seal
Figure 47—Installing the Front Head Seal
Important
• Do not let the sealing area around the cen
ter bore of the head touch the shaft as the
head is lowered.
• Do not rotate the front head (16) to line up
with the dowel pins because this will con
tact the reed container.
14. Seal (17) to the front head (16) (figure 47).
• Lubricate the seal (17) and groove with clean
525 viscosity refrigerant oil.
15. Shell (9) to the internal assembly (figure 48).
• Coat the inside of the shell (9) with clean 525
viscosity refrigerant oil.
• Position the shell (9) on the internal assembly.
Rest the shell (9) on the seal.
• With the flat side of a small screwdriver, posi
tion the seal (17) in a round, circle shape to
the inside of the shell (9).
• Slide the shell (9) down. Line up the oil sump
with the oil intake tube hole.
16. New dowel pins (20) to the rear cylinder half.
• Remove J 21352.
• Install the compressor into J 9396.
17. Seal (43) to oil pick-up tube (44).
18. Oil pick-up tube (44) to the compressor (figure 49).
• Lubricate the oil pick-up tube (44) with clean
525 viscosity refrigerant oil.
• Place the oil pick-up tube (44) in the cavity.
• Rotate the compressor assembly to align the
tube (44) with the hole in the shell baffle.
19. Seal (31) and bushing (30) to the rear of the dis
charge cross-over tube (26).
F1635
L. Oil Sump
Area
M. Oil Intake
Tube Hole
9. Shell
17. Seal
48
Figure
20. Rear suction reed (48) over the dowel pins (45).
• Place the slot toward the sump.
21. Rear discharge valve plate (49) over the dowel
pins (45).
• Place the reed retainer up.
22. Inner oil pump gar (50) over the shaft (39).
• Line up the identification marks.
23. Outer oil pump gear (51) over the inner gear (fig
ure 50).
• Line up the identification marks.
• Face the compressor oil sump and position the
outer gear (51) so that it meshes with the inner
gear (50) at the 9 o'clock position. The cavity
between the gear teeth will be at the 3 o'clock
position.
24. Seal (52) to the discharge valve plate (49).
• Lubricate the seal (52), shell (9), discharge
plate (49) and gears (50 and 51) with 525 vis
cosity refrigerant oil.
25. Suction screen (58) to the rear head (54).
• Lubricate the surface of the rear head (54) with
525 viscosity refrigerant oil.
— Installing the compressor Shell
F1393