Personal Recipient Messages; Recordable Personal Recipient Messages (Tunstall Vi+ Only); Speech Configuration - Tunstall ConnectMe Vi+ Installation And Programming Manual

Personal recipient messages

Dealing with personal recipient calls from a touch-tone telephone
Alarm calls can be sent to personal recipients, when a personal recipient receives an
alarm call they will hear a spoken message 'This is an alarm call from' followed by
either the Unit ID or a recorded message e.g. Mrs Smith (Tunstall Vi+ only – see next
section). The recipient can then handle the call using their keypad as follows:
Function
Accept Call
Clear Call
Volume up
Volume down
Talk
Listen

Recordable personal recipient messages (Tunstall Vi+ only)

A personal recipient message can be recorded on the Tunstall Vi+ home unit to
replace the ID message that a personal recipient would normally hear when they
receive an alarm call.
To record the message:
Firstly enter programming mode on the Tunstall by holding the cancel button down
until it beeps, then press the following on the connected telephone keypad.
Note: if a message is already recorded, this key sequence will replay the message. If
this is the case the message must be deleted before a new message can be
recorded.
To delete the message, press:

Speech configuration

This feature configures how the speech prompts programmed into the home unit are
used during alarms, local warnings and programming. Please see the help files within
PC Connect for more details. Tunstall Vi+ offers complete speech configuration.
ConnectMe Tunstall Vi+ Installation and Programming Manual
Button Notes
5
* then # Call must be accepted first
1
Alters home unit volume
2
7 Only required if mode is changed from Hands-
* free Voice Switched (HVS) to tone switched by
pressing 7 followed by *.
Then record the message,
press * to end the recording. If using the keypad
press cancel to stop recording
40