Table of Contents
Advertisement
Manual
3.
MERCURY 8-LINE PAGER INSTALLATION
Follow these instructions to install and setup your Mercury Wall Pager.
1. Ensure the unit has been programmed correctly to suit the installation. (see the
programming manual)
2. Screw on the hi-gain antenna onto the side of the unit and ensure it points
upwards.
3. Plug the plug-pack charger into a power outlet nearby. Plug the other connector
on the plug-pack into the Mercury 8-line wall pager.
4. Mount the unit on a wall if required. You will need 2 screws in the wall
horizontally spaced 40mm apart.
CommtechWireless
©
Mercury 8-line Wall Pager
Page
7
Advertisement
Table of Contents
