Table of Contents
Advertisement
GHOST
User Manual Status 04/2009 // Spec 2010
1.
Pull the brake calliper alternately in all directions with your hands.
•
The brake calliper must not move.
2.
Check your brake system for leaks:
•
Pull the respective brake lever with the bike at a standstill and hold the
brake lever in this position.
•
Inspect the brake system from the brake lever along the lines up to the
brakes.
•
No hydraulic fluid should escape at any point.
3.
Inspect the brake disc for damage:
•
It must not exhibit any dents, cracks, deep scratches or other mechanical
damage.
4.
Raise the front and rear wheels alternately and turn the wheel by hand:
•
The brake disc may only have a minimal lateral runout.
5.
Have the wear of the brake pads and brake disc checked in an approved
workshop (see also chapter 11):
•
The brake pads must not be worn beyond the wear indicator.
•
The thickness of the brake disc must not be below the specified minimum.
•
For the minimum thickness, please refer to the enclosed component
instruction manual.
6.
Inspect the brake discs for soiling, in particular for oil or grease.
•
Soiled brake discs must be cleaned immediately (see chapter 11).
During prolonged tours over several days the brake disc, brake blocks and
brake pads can become severely worn.
Always take replacement brake blocks and replacement brake pads with you
on such tours.
Carry out the replacement yourself only if you are familiar with this work.
Please consult your dealer.
6.51
Hide quick links:
Advertisement
Table of Contents
