Ghost Bike User Manual page 124

GHOST
User Manual Status 04/2009 // Spec 2010
Danger of material damage!
Cleansers, lubricants and corrosion inhibitors are chemical products.
Incorrect use can damage your bike.
Use only products that are expressly suitable for bikes.
Ensure that these substances do not attack paintwork or rubber, plastic
or metal parts. Contact your dealer for further advice.
Observe the manufacturers' instructions for use of the products.
4. Rinse off the whole bike with a gentle water spray and allow it to dry.
5. Clean the chain:
•
Pour a small amount of a suitable chain cleansing agent onto a clean, lint-
free cotton cloth and wipe off the chain.
Rotate the chain slowly opposite the drive direction while wiping.
•
Repeat this procedure as often as necessary with a clean part of the cotton
cloth until the chain is clean.
•
Allow the cleansing agent to evaporate for approx. 1 hour.
If there is still cleansing agent between the chain links, the new lubricant will
be immediately degraded and therefore has no lubricating effect.
•
Apply lubricant suitable for bike chains sparingly to the chain links.
Danger of material damage!
Lubricant for motorbike chains will clog your bike chain and drive components.
Use only lubricants expressly approved for use on bike chains.
Danger of personal injury and material damage!
If too much lubricant is applied, it can drip onto and soil the wheel rim and
brake disc. This would reduce the braking effect.
Remove any excess lubricant from the chain using a clean, dry and lint-
free cotton cloth.
Clean the wheel rim and brake disc with a suitable degreasing agent.
Please consult your dealer.
Danger of personal injury and material damage!
If spray wax or corrosion inhibitor gets onto the wheel rims or brake discs
and/or the brake blocks or brake pads, this will reduce the braking effect.
Clean these parts using a suitable degreasing agent Please consult your
dealer.
6. Clean any remaining heavily soiled parts by hand using a suitable clean and
lint-free cotton cloth and a suitable cleansing agent.
7. Spray the whole bike with a suitable spray wax or similar corrosion inhibitor.
11.124