Table of Contents
Advertisement
I nsta l l a tio n a nd St art -u p
Figure 6: USB port (1)
5.9.3
PC does not recognise the device
The device has been connected to the PC before the software and drivers have
been installed, and is not recognised by the PC. To fix this problem follow these
steps.
Open Device Manager
1.
Control Panel
2. System
3.
Hardware
4. Device Manager
Installing/Reinstalling device drivers
1.
Right-click on piccoLOG under "Other devices" (yellow question mark) .
2. Update drivers
»
Hardware update wizard will open
3.
Choose "No, not this time"
4. Choose "Automatically install software"
5.
If an error message occurs, click on "Continue installation"
»
Device should no longer appear under "Other devices"
Page 18
1
Operating manual Powador-piccoLOG_EN
Advertisement
Table of Contents
