Pride RALLY 3 Owner's Manual page 30

V I I I . D I S A S S E M B L Y A N D A S S E M B L Y
Always disassemble or assemble your scooter on a level, dry surface with sufficient room for you to work
and move around your scooter. Keep in mind that the disassembled sections of the scooter take up more
floor space than the assembled scooter.
DISASSEMBLY
WARNING! Lifting weight beyond your physical capability may result in personal injury. Ask for
assistance when necessary while disassembling your scooter.
1. Remove the key from the key switch. See IV. “Your Rally.”
2. Pull up on the manual freewheel lever. See IV. “Your Rally.” Putting your Rally in freewheel mode
makes it easier for you to maneuver the rear section because the drive wheels are free to turn.
3. Lift the seat up and off of your scooter.
4. Gently lift the rear shroud off of your scooter. The rear shroud is held in place with a reusable fastener.
5. Unplug both battery harness connectors. See figure 15.
6. Remove the battery straps and lift both batteries from the battery wells.
7. Unplug the large, white, 9-pin front-to-rear connector that connects the front control console assembly
harness to the electronic controller assembly harness. See figure 15.
CAUTION! Failing to unplug both battery harness connectors and the front-to-rear connector prior
to further disassembly could result in permanent damage to your scooter.
BATTERY HARNESS CONNECTORS
FIGURE 15. BATTERY HARNESS CONNECTORS/
FRONT-TO-REAR CONNECTOR
Separating The Front And Rear Sections
1. Lower the scooter’s tiller to the centre of the floorboard by turning the tiller adjustment lever anticlockwise
until it is loose. Press the tiller release buttons and lower the tiller to the centre of the floorboard.
Tighten the tiller adjustment lever.
2. Pull up on the front-to-rear locking lever (releases the locking pin) with one hand, and push on the seat
pedestal to pivot the scooter’s rear section rearward with your other hand—far enough so the rear
section’s upper pegs come free of the front section’s upper slots. See figures 16 and 17.
3. With one hand on the seat pedestal and one hand on the frame handle, slightly lift the front section and
slide the front and rear sections apart. See figures 17 and 18.
30
FRONT-TO-REAR CONNECTOR
FRONT-TO-REAR LOCKING LEVER
FIGURE 16. FRONT-TO-REAR LOCKING LEVER
LOCKING PIN
Rally