FCC Rules. are subject to change at any time without prior notice. ID TECH is a registered trademark of International Technologies & Systems Corporation. VersaScan II and Value through Innovation are trademarks of International Technologies & Systems Corporation. - 1 -...
High-Speed Long Range Scanning Dimensions(L)x(W)x(H): 6.3 inches(160mm) x 2.7 inches(69mm) x 3.5 inches(88mm) The VersaScan II enables quick scanning of barcodes up to 5.1 inches in width at Weight: 4.4oz (125g) / without cable distances up to 8.7 inches away. Small or high-density bar codes as well as damaged...
Page 4
7. Scan a bar code to confirm that data shows up in a terminal program such as Hyper Terminal. The VersaScan II is designed to switch easily between interface options. To switch Notes: from one interface to another, the appropriate cable must be installed. To change a cable, simply follow these steps: 1.
Page 5
Section 4 Section 5 READING MODE SETTING INTERFACE/ COMPUTER TYPE SETTING Please simply scan one of the following bar codes to change the Please simply scan one of the following bar codes in each reading mode to the desired one. The default reading mode is subsection to set your scanner to the proper interface and indicated in bold and underlined characters.
Section 6 Section 7 PDF 417 & DATABAR(RSS) TROUBLESHOOTING Before troubleshooting the problem, try this: PDF 417 and most Databar variants are disabled in default settings; you may enable them by scaning the enable barcode for the desired 1. Unplug the cable from the computer. symbologies as follows.
Need help?
Do you have a question about the VersaScan II and is the answer not in the manual?
Questions and answers