Table of Contents
Advertisement
chain bar. On reassemble if the chainsaw is still not working. Please take it to an authorized service centre.
Avoiding kickback
Be constantly aware of the position of the upper quadrant of the blade tip. This is the part that triggers a kickback
when it hits resistance.
Never engage the upper quadrant of the guide bar with whatever you are cutting. Look out for hidden branches or
obstructions. Ensure there is a clear work area.
Always clear away brush, vegetation and any obstructing debris before attempting a cut that might trigger a
kickback.
Avoid cuts that will cause the chainsaw to jam in a tree trunk or limb.
Avoid jamming
Always cut into the compression wood first until the cut starts to close. Always make the compression cut beneath
of the log or limb is suspended from one end and on top if it is supported at both ends. Cut from the other side
towards the compression cut. Make a habit of using a wedge to prevent the compression cut jamming tighten the
chainsaw blade.
Power cord support
During use of the chainsaw the power cord will continually be pulled as you move from one area to another.
A cord retention hook (photo.) has been provided on housing of the chainsaw.
Before start-up
1.
Check the machine and cable are in good working order before starting the chainsaw.
2.
Make sure that the chain lubrication is working and check the oil level.
3.
Check the chain tension and the operation of the chain brake.
Start up and stop
1.
Remove the bar cover.
2.
Release the chain brake by pulling the front hand guard, firmly towards the back of the electric chain saw until
a click is heard. To check the chain brake has been released, you should be able to move the chain by hand.
3.
Connect the cable to the power.
Note. Ensure the brake is working efficiency, check its operation every time you use the chain saw before
commencing work with it.
WARNING. The on/off switch must never be depressed before pulling back the front hand guard.
4.
Hold the electric chain saw by its grip with both hands.
5.
To start the chainsaw, push the lock-off button forward and squeeze the switch lever (ON/OFF) towards the
handle. Release the lock-off button
6.
To stop the chain saw, release the switch lever (ON/OFF)
WARNING. Hold the electric chain saw with both hands until the chain is completely still.
Operating the electric chain saw
Safe chainsaw operation whilst cutting - always:
1. Run the chainsaw motor at full revs. This makes the job safer, as there is less chance of pull-in or kick-back.
2. Position your body to the left of the chainsaw so if it kicks back uncontrollably, it goes over your right shoulder.
3. Keep a firm grip with your left hand on the front handle, with your thumb securely below the handle. The swivel
of your wrist in a kick-back situation will activate the chain brake.
4. Make sure the chain is tensioned correctly.
5. Observe the size of wood shavings, if they become dusty your chain probably needs sharpening.
- 6 -
Hide quick links:
Advertisement
Table of Contents
