H3 Bottom View - MotoSAT H3 User And Installation Manual

LAN > RJ45 > is the Network Interface to communicate to a Local Computer, Router,
and Satellite Modem. This Port has configuration tools that make it extremely flexible
for almost any user requirement. See H3 Configuration for additional information.
LNB RX Out > F Type > connects to the Satellite Modem/Router. When connected the
H3 Controller can monitor the DC Voltage supplied to the LNB and allows the LNB
located on the Satellite Antenna Mount to be shared by both the H3 Controller and the
Satellite Modem at the same time with no external splitters or switches required.
LNB RX In > F Type > connects to the LNB located on the Satellite Antenna. This
input receives L Band Signals 950-2050 MHz and supplies LNB DC Volts.

H3 Bottom View

Located on the bottom side of the H3 Controller is the Product Label. This label should
include the Product Model and Series number, Date of Manufacturer, FCC, CE, and UL
certifications that apply, along with a simplified wiring connection detail.
On the following page is the Typical H3 Wiring Diagram. This is a generic wiring
example of a MotoSAT DataStorm System.
For proper operation the Power Supply used with the H3 Controller must meet the power
needs of the Dish Mount (see diagram below).
Always use the Control Cable supplied with the Dish Mount and follow wiring color
codes.
70