Messages; Configuration; Clock Frequency - Siemens D1107 Additional Technical Manual

Mechanics

Messages

Message LED:
The Message LED (frontpanel connector) shows two different states
A slow blinking (once a second) of the LED signals that any application has received
a message. (ACPI- mode)
A fast blinking (five times a second) of the LED signals a hardware problem. More
detailed information are shown with an additional System Monitoring Software or on
the monitor after reboot entering Bios Setup (menu Advanced System Management) .
The fast blinking LED can have several different causes.
BIOS: Please refer to BIOS description on the including CD-ROM.

Configuration

Clock frequency

The switches may only be set as specified in the tables below for the particular
!
Pentium II or Celeron used.
There are also Pentium II and Celeron processors, which automatically always operate at
the proper frequency, regardless of the switch position.
As these new processors do not differ externally from the previous processors, we
recommend always setting the switches in accordance with the processor.
This system board you may use with Pentium II processors with 66 MHz and 100 MHz
Front Side Bus or with Celeron processors with 66 MHz Front Side Bus.
Information on which processors can be used is available from your sales office or the
customer service center.
Pentium II with 66 MHz Front Side Bus:
Processor
300 MHz
333 MHz
Celeron with 66 MHz Front Side Bus:
Processor
233 MHz
266 MHz
300 MHz
333 MHz
366 MHz
400 MHz
433 MHz
14 - English
- a necessary sensor is missing or defect
- an available sensor has overtemperature
- a fan is defect or not working properly
- a software is responsible for blinking
switch 5
off
on
switch 5
off
on
off
on
off
on
off
switch 6
on
off
switch 6
off
on
on
off
off
on
on
switch 7
off
off
switch 7
on
off
off
off
off
on
on
A26361-D1107-Z180-6-7619
switch 8
on
on
switch 8
on
on
on
on
on
off
off