Windows 2000 - Contemporary Controls CTRLink EIAR-10T User Manual

Configuration
If your Ethernet network address is also 192.168.1.0, you may skip the
following instructions. In this case, you can proceed with Section 4.1
Configuring options.
In the operating systems Windows NT-SP6, Windows 2000,
Windows XP or Linux/Unix, you may assign the network card of the
appropriate computer more than one IP address (see Section 4.2.1.1
and Section 4.2.1.2). In addition, it is still possible to use the configuring
options "via the telephone network" or "via the serial interface" (not
recommended).
4.2.1.1

Windows 2000

To assign a network card one or several IP addresses under
Windows2000, administrator rights are required.
Log in as administrator and open the Control Panel → Dial-Up
Networking. Display the properties of your LAN connection:
On this tab, select Internet Protocol (TCP/IP) and click on
"Properties". You will see the current configuration of your network card
(IP address, Gateway, DNS etc.) in the window which then appears.
These settings remain unchanged. If you click on "Advanced" the
window shown below appears.
4-20