Temperature Reporting; Remote Start Time-Out Alert - Viper 4204 Owner's Manual

by the installer (default 6 starts). Timer Start is exited after the
final start.
Smart Start operation
Smart Start uses the settings for Timer Start in addition to tempera-
ture and battery level to automatically start the engine. Activation
begins the countdown timer. When the timer expires the vehicle
interior temperature and battery level is checked and, if the Tem-
perature is above 100F, below 0F, or the battery level is be-
low 10.5v, the engine will start. When the Remote start runtime
expires the engine shuts off, and the countdown timer restarts.
Smart Start is exited after the final start.
Note The temperature and battery thresholds can be changed by
an authorized Directed dealer if a higher or lower threshold
is desired.

Temperature Reporting

During Remote start the vehicle interior is checked regularly for temper-
ature changes. If a change in temperature is detected this report will
be sent to the remote for display. Each time the remote receives this
report it will beep and display the temperature as described for the
Temperature Request in the Advanced Commands section Level 1.
Note Temperature report must be turned on by an authorized Di-
rected dealer.

Remote Start Time-out Alert

During remote start a message is sent three minutes before and again
at one minute before the engine turns off. The
LED flash and several tones play as an alert to reset the runtime if
desired.
© 2011 Directed Electronics. All rights reserved.
LED, Remote Start
21