Connecting Two Parallel Devices; Cmos Messages - @Xi Computer Corporation Mtower User Manual

Appendix A, Frequently Asked Questions

Connecting Two Parallel Devices

CMOS Messages

?
How can I connect two parallel devices to my computer?
!
Like other computers, your @Xi computer comes with a single parallel
connector. If you want to connect two parallel devices to your computer, find
out whether one of those devices has a pass-through connector that lets you
attach a parallel device to it. For example, parallel versions of external
drives from Iomega® Corporation (zip® and jaz®) have a pass-through
connector on the back of the unit that lets a second parallel device (such as a
printer) share the parallel drive to which the Iomega® drive is connected.
If you prefer, you can add an optional input-output card inside your
computer to add a second parallel port and connect a second to the extra
parallel port. Alternatively, you can connect both parallel devices to an
external manual switch.
?
When I turn my computer on, the message "Press F1 for setup" appears.
What is this, and do I need to press F1 to get my computer set up?
!
No. Pressing the F1 key while your computer is starting lets you access your
computers CMOS setup. CMOS setup lets you change your system settings.
When you receive the computer from @Xi Computer Corporation, there are
no changes that need to be made. Changes are typically made to the CMOS
when hardware is changed or added so that system resources can be
configured to support it. Changing settings in the CMOS is recommended
only for advanced users, or on the advice of technical support. Changing
these settings can cause problems if they are not set correctly.
Page 78