Viking F-1 Installation Instructions Manual page 39

LED References
Use the table below to identify the corresponding "TS Ref#" and refer to page 38-41 for
further troubleshooting.
# LED
9 "C Loop"
10 "Open"
11 "STOP"
12 "Close"
13 "Siren"
14 "Aux. Pwr"
15 "Diagnose"
16 "Close Limit"
17 "Open Limit"
18 "ODS"
19 "Timer"
20 "AC VOLTAGE INPUT"
21 "PROTECTION WORKING"
22 "AC VOLTAGE OUTPUT"
23 "AC POWER"
VIKING TECHNICAL SUPPORT 1.800.908.0884
Status Meaning
OFF Normal Condition.
SOLID Control Board is receiving an input from a device connected to the
C Loop terminal (pg 32, 42).
OFF Normal Condition.
SOLID Control board is receiving an input from a device connected to any of
the following input terminals: Exit, Fire, Strike or Open (pg 31, 42).
OFF Normal Condition.
SOLID Control Board is receiving an input from a device connected to the
Stop terminal (pg 31, 42).
OFF Normal Condition.
SOLID Control Board is receiving an input from a device connected to the
Close terminal (pg 31, 42).
OFF Normal Condition.
SOLID Second consecutive obstruction has been detected. (pg 26).
FLASHING Batteries are critically low.
OFF No voltage output on these terminals at the moment.
SOLID There is 24VDC output on these terminals at the moment.
OFF Normal Condition.
FLASHING Errors have been detected; Check LCD Display for ERR messages (pg 40).
OFF Gate is not at the close limit position.
SOLID Gate is at the close limit position.
FLASHING Indicates a problem with the limit switches or wires. (pg 20-21).
OFF Gate is not at the open limit position.
SOLID Gate is at the open limit position.
FLASHING Indicates a problem with the limit switches or wires. (pg 20-21).
OFF Normal Condition.
SOLID Obstruction has been detected. (pg 26).
FLASHING Overload has been detected. (pg 26).
OFF The close timer is turned OFF or gate is not at the open limit if the timer is
turned ON. (pg 24).
SOLID Gate is at Open Limit, Timer is turned ON and counting down to close. (pg
24).
FLASHING Gate is at Open Limit, Timer is turned ON but is not timing out due to a
conflicting command. (pg 24).
SOLID Normal Condition.
OFF Incoming power to Power Supply Panel Assembly is not sufficient.(pg 18).
SOLID Normal Condition.
OFF EMI Board is damaged and circuit is not protected . Replace EMI Board.
SOLID Normal Condition.
OFF There is no output voltage from the Power Supply Panel Assembly.
SOLID Normal Condition for High Voltage installations.
OFF High Voltage is not supplied to the Modular Power Box (pg 18).
TROUBLESHOOTING
Pg 41
TS Ref#(s)
9, 10
9, 10
9, 10
9, 10
11, 13, 1, 2
1, 2
6
6
11, 13, 1, 2
11, 13, 1, 2
9, 10
1
2
1
3 7