Ðóñ SMART RM 2000/3000 2U 7. ÐÅØÅÍÈÅ ÂÎÇÌÎÆÍÛÕ ÏÐÎÁËÅÌ Проблема Причина Решение ИБП не включается или 1. ВКЛ/ВЫКЛ/ТЕСТ кнопка не нажата. 1. Нажмите еще раз. не выключается. 2. Короткое замыкание на выходе или 2. Отключите часть нагрузки, включите произошло отключение из за перегрузки.
Page 12
USER’S MANUAL SVEN Power Smart RM 2000/3000 2U UPS (vertical, horizontal placement, assembling into wallmount) Please read this operation manual before using the unit and retain this operation manual in safe place for future reference...
Page 13
SMART RM 2000/3000 2U Thanks for your purchasing the Sven Smart UPS product. Please read the USER’S MANUAL before using the Sven Smart UPS product. INFORMATION TO USER Changes or modifications to this equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
USER’S MANUAL 1. INTRODUCTION Thank you for purchasing our Smart Rack Series UPS. Please read the USER’S MANUAL before installing your UPS since it contains information that should be followed during the installation process. It also provides the UPS specifications, safety instructions, and trou- bleshooting guide along with the customer support information.
SMART RM 2000/3000 2U 5. INSTALLATION 5.1 Conditions The UPS units are intended for use in a temperature-controlled, indoor area free of conductive contaminants. Select a location that will provide good air circulation for UPS at all times. Do NOT operate the UPS in an environment where the ambient temperature does not meet specifications.
USER’S MANUAL 5.6 Overloads instruction Do not plug in equipment over 1400W for Smart RM 2000, or 2100W for Smart RM 3000. Overload percentage (%) On AC mode UPS Status Alarm sounds every 3 sec for 2 beeps but the UPS won`t shut down due to this overload 110% conditioncontinuously but the UPS won’t shut down due to this overload condition.
Page 17
SMART RM 2000/3000 2U (II) Mute Switch Press and hold this button for 1 second, the UPS will mute the alarm after a short beep. Press and hold this button for another 1 second, the UPS will restore the alarm function after a short beep.
USER’S MANUAL 7. TROUBLESHOOTING Problem Possible Cause Action To Take UPS will not turn on or off. On/off/test button not pressed. Press again. Output short or overload shutdown. Reduce the load then reset the break er by pressing the plunger back in. Computer interface or accessory problem.
Page 19
SMART RM 2000/3000 2U Front panel LED Indication Table Green Yellow Yellow Red LED Alarm UPS Status LED (I) LED (II) LED (III) Indication AC Mode Blink AVR mode 4 beeps every 10 sec DC Mode Internal fault 1 beeps every 1 sec...
Need help?
Do you have a question about the Smart RM 2000 and is the answer not in the manual?
Questions and answers