Operating Surface Elements - Amana ARK7700 Use And Care Manual

Operating the Single Radiant Element
Push in and turn the control knob to the desired
setting. The radiant element will cycle on and
off to maintain the desired heat setting.
When Finished
Turn control OFF.
Operating the Dual Radiant Element
The double lines between settings on the dual
radiant element control knob indicate both the
inner and outer elements are being used. The
single lines indicate that only the inner element
is being used.
To operate the inner and outer element, push in
and turn the control knob to the double line
settings. To operate only the inner element,
push in and turn the control knob to the single
line settings.
The dual radiant element will cycle on and off to
maintain the desired heat setting.
When Finished
Turn control OFF.
Operating the 10 Position Haloring@
Element
Push in and turn the control knob to the desired
setting.
There is a distinct click position for all 10 settings.
The 10 position switch allows a precise constant
amount of heat to radiate from the element.
Therefore, the same heat settings can be
repeated and maintained.
The Haloring@ element will not be illuminated at
settings LO through 3. When using settings 4
through HI, the higher the selected temperature
the brighter the illumination from the element.
The Haloring element will not cycle unless it
has been left at a high heat setting for an
extended amount of time without a pan in place
or if the pan has boiled dry.
When Finished
Turn control OFF.
Operating The Surface Elements
Single Radiant Element Control Knob
Dual Radiant Element Control Knob
10 Position Haloring@ Element
Control Knob