Tipping Radius; Product Dimensions - KitchenAid Bottom-Mount Built-In Refrigerator Installation Manual

If the water pressure to the reverse osmosis system is less than
40 to 60 psi (276 to 414 kPa):
Check to see whether the sediment filter in the reverse
osmosis system is blocked. Replace the filter if necessary.
Allow the storage tank on the reverse osmosis system to refill
after heavy usage.
If your refrigerator has a water filter cartridge, it may further
reduce the water pressure when used in conjunction with a
reverse osmosis system. Remove the water filter cartridge.
If you have questions about your water pressure, call a licensed,
qualified plumber.

Tipping Radius

Be sure there is adequate ceiling height to stand the refrigerator
upright when it is moved into place.
The dolly wheel height must be added to the tipping radius
when a dolly is used.
If needed, the tipping radius can be reduced. See "Reduce
Tipping Radius."
Side Tipping Radius (36" [91.4 cm] Models)
90 "
(229.9 cm)
A. Tip this side only
Side Tipping Radius (42" [106.7 cm] Models)
93"
(236.2 cm)
A. Tip this side only

Product Dimensions

Side View
The depth from the front of the top grille to the back of the
refrigerator cabinet is 25 " (64.5 cm).
The power cord is 84" (213 cm) long.
8
A
A
The water line attached to the back of the refrigerator is 5 ft
(1.5 m) long. Height dimensions are shown with leveling legs
extended " (3 mm) below the rollers.
*83 "
(211.8 cm)
84" (213.4 cm)
Power Cord
*When leveling legs are fully extended to 1 " (3.2 cm) below
rollers, add 1 " (2.9 cm) to the height dimensions.
Top View
36" (91.4 cm) Models
35 "
(89.5 cm)
42" (106.7 cm) Models
4
(105 cm)
25 "
(64.5 cm)
23 "
(59.7 cm)
*3 " (8.9 cm)
25 "
(64.5 cm)
"
25 "
(64.5 cm)